25
CONTENTS
MANUAL GROUND BALANCE
Ground Balance can be manually adjusted until the
minimum amount of ground signal is present.
1. Press the Settings button to navigate to the Ground
Balance setting.
2. Raise and lower the coil repeatedly over a clear patch of
soil that does not contain any targets.
Listen to the audio response to interpret the result of
the Ground Balance; a low tone indicates that you should
increase the Ground Balance value and a high tone
indicates that you should decrease it.
3. Press the Minus (–) and Plus (+) buttons to manually
change the Ground Balance value until the minimum
amount of ground signal is heard. The Manual Ground
Balance value is shown on the Target ID Display.
TRACKING GROUND BALANCE
When Tracking Ground Balance is active, the detector
continuously adjusts the Ground Balance automatically
during detecting. This ensures that Ground Balance is
always set correctly.
Tracking Ground Balance can be useful for
detecting in salt water (coil submerged) in
Beach Mode 2.
Press the Settings button to navigate to the Ground
Balance setting.
4. Press the Accept/Reject button to toggle Tracking
Ground Balance On/Off.
When Tracking Ground Balance is On, the Tracking
Indicator will appear on the LCD, and Ground Balance will
track automatically in the background.
Ground Balance (Continued)
To Next Page
Loading...
Need help?
General
