- 10 -
MINGDA TECHNOLOGY CO.,LTD
www.md-3d.com
diameter of the nozzle. If the nozzle is 0.4mm, the recommended wall thickness is 1.2.
3) Enable Retraction: MINGDA recommended to select.
4) Bottom /Top Thickness: The wall thickness above and below the model is generally an integral multiple of
the layer thickness. It is recommended to be the same as the wall thickness and set to 1.2.
5) Fill Density: The filling density inside the model can be set to 10%~100% according to the actual situation.
The larger the value, the denser the interior.
6) Print Speed: The moving speed of the print head during printing. It is recommended to set the low speed of
the complicated parts and the high speed printing of the simple parts. Generally set around 30-50, recommended
PLA setting 50, ABS setting 30. (Global speed defaults to print speed).
7) Printing Temperature: the temperature used by the nozzle to melt the consumables, the consumables of
different manufacturers. The melting temperature is different. It is recommended to set the PLA to 190 degrees and
the ABS setting to 230.Excessive or too low temperatures can cause plugging.
8) Bed Temperature: print platform temperature, recommended PLA setting 50 °C, ABS setting 80-110 °C.
9) Support Type: support mode when printing a model with a suspended part, “None” means no support,
“Toutching buildplate” means creating support that can reach the workbench part, “Everywhere” means that all
parts are suspended Create support. It is recommended to select "Everywhere".
10) Platform Adhesion Type: None defaults to print one layer at a minimum, Brim refers to a skirt, and Raft
refers to a bottom plate. It is recommended to select Raft, the PLA first layer Airgap is set to 0.15, and the ABS first
layer Airgap is set to 0.1 or lower.
11) Diameter: The filament supplied is 1.75mm.
12) Flow: Default 100.
3. Advanced Setup:
1) Nozzle Size: Nozzle diameter is generally 0.4mm. If you customize other nozzle sizes, fill in here. The nozzle
size does not affect the accuracy of the layer thickness and only affects the minimum print detail. The size of the
nozzle and the printing speed are squared, and increasing the nozzle size greatly increases the printing speed.
2) Speed: The speed of retracting consumables is generally 50.
3) Distance: The length of the retractable consumables, the specific length depends on the actual situation of
To Next Page
Loading...
