37
4. Connect the body adapter to one of the head adapters (using the
included cable or network cable).
5. Cable the remaining heads together in series.
6. Set an ID number for each head, using the rotary switches on the
adapters.
● ID numbers run from 00 to 29. The left rotary switch sets
the first digit, and the right switch sets the second digit.
● Be sure to set a different ID number for each head.
● When you switch the power ON, the body reads in the ID numbers and sets itself up
accordingly. Note that the body will not check the IDs again so long as power remains on.
Consequently, it will not recognize any changes that you make to the ID settings while
operation is in progress. Be sure to set the power switch to OFF (“
”) before changing any
of the ID settings.
You might find it helpful to print ID labels and attach them to the corresponding head
adapters. This will make it easier to keep track of the correspondence between the
heads and the ID numbers.
▼ If head adapter is set to ID “09”, attach a “9” label.
First
digit
Second
digit
To Next Page
Loading...
