38
(Highest assigned ID number)
MULTI 0
MULTI 1
MULTI 2
MULTI 29
8. Set the HOLD button into RUN position.
◆ The CHROMA METER begins taking measurements from
all heads. The display shows the measurements taken
by the selected head (the head whose ID number is dis-
played at the upper right).
● You can select a different head by pressing [▲] or [▼] as
necessary. (Press [▲] to cycle upward through the ID
numbers, or [▼] to cycle downward.)
7. Set the power switch to ON (“|”).
◆ The upper right of the screen shows the lowest used ID
number.
● Press [▲] or [▼] as necessary to cycle up or down through
the used ID numbers. Confirm that the display cycles
through the IDs for all of the connected heads. (The illus-
tration at left shows the cycle sequence when the [▲]
button is used.)
● If the display skips any of the IDs that you have set, check
the relevant cable connections. Also check again to make
sure that all IDs are unique.
(Highest assigned ID number)
MULTI 0
MULTI 1
MULTI 2
MULTI 29
To Next Page
Loading...
