11
Installing the Batteries
WARNING
Do not allow batteries to come into contact with fire, and do not charge them (unless they
are specifically designated as rechargeable), heat them, or take them apart. Any of these
actions may cause batteries to overheat or explode, possibly resulting in fire or injury.
CAUTION
Do not use battery types that are not specified for this instrument. Never mix old and
new batteries, or different types of batteries. Be sure to load batteries with the (+) and
(–) polarities in the correct direction. Neglecting any of these precautions may result in
battery leakage or explosion, possibly resulting in fire, injury, or environmental dam-
age.
1. Set the power switch to OFF (“ ”). Press down lightly on the bat-
tery cover and pull it off.
● Have two AA batteries ready.
2. Place the batteries into the compartment. Be sure that the + and –
ends match the markings in the compartment. Then reattach the
cover.
● When replacing batteries: Remove both of the old batteries first, and then install the new
batteries.
To Next Page
Loading...
