7-14
3. Function Combination Matrix
Chapter 7
Miscellaneous
Conditions for Combined Functions
❍ : The combination is possible.
● : Either of the functions which is set first takes precedence.
✕ : Either of the functions which is set last takes precedence.
: One of the functions must be canceled before a copy cycle can be initiated.
▲ : The combination is disabled in Single-Sided Double-Sided Mode and the function set first takes
precedence.
A : The combination is impossible if the Paper Size is input by custom size and the function set first
takes precedence.
B : Auto Size is automatically selected.
C : The Mixed Original Detection mode is valid regardless of whether Mixed Orig. Detect is turned ON
or OFF.
D : The Mixed Original Detection mode is valid for Auto Detect and not valid for Size Input regardless
of whether Mixed Orig. Detect is turned ON or OFF.
E : Booklet Creation and Back Cover cannot be combined. (Booklet Creation takes precedence.)
F : The zoom ratio is automatically changed to Full Size.
G : No zoom ratios can be stored in memory in the Interrupt mode.
H : The function set last takes precedence. (Auto Paper is automatically selected.)
I : The function set last takes precedence. (Non-Sort is automatically selected.)
J : The function set last takes precedence. (Sort is automatically selected.)
K : Functions only when Separation and Double-Sided Copy are set with a Book original being used.
L : The functions cannot be combined only for Separation. (The function set first takes precedence.)
M : The combination is not possible only if Auto Paper is used, and Staple is automatically canceled.
(The combination becomes possible when it is further combined with Z-Fold.)
N : The combination is not possible only if Auto Paper is used with an FN-5 installed, and Staple is
automatically canceled. (The combination becomes possible when it is further combined with Z-
Fold.) When an FN-105/FN-106/FN-503 is installed, the combination is not possible only if the
document loaded contains pages of different widths with Auto Paper used. (Staple is automatically
canceled.)
P : When the machine is equipped with an FN-5, the function set last takes precedence (and Center
Staple is automatically selected). When the machine is equipped with an FN-105/FN-106/FN-503,
the function set first takes precedence.
Q : The combination is not possible only if the finished size of Z-Fold differs from the size of the cover
or interleaf. The function set first takes precedence. (Neither the cover nor interleaf can be folded in
Z-fold.)
R : The combination is possible only when the FN-105 is mounted. When the machine is equipped with
an FN-5/FN-106/FN-503, the function set first takes precedence.
S : The function set last takes precedence. (Center Staple is automatically selected.)
T : 2-Point Side Staple is automatically selected.
-:Hasnobearing
▼
To Next Page
Loading...
