3-11
3. Selecting the Paper
Making Copies
Chapter 3
Manual Bypass Copying
• Use Manual Bypass to make copies on paper not loaded in any drawer, or to copy onto OHP
transparencies, thick paper, or any other special paper.
• When using the Multi Bypass Tray, you can load multiple sheets of paper.
• The setting of the paper size is needed for manual bypass copying.
• Manual Bypass cannot be used for a reserved job.
◆
Types of Paper
• Plain paper (weighing 16 lb to 24 lb)
• Recycled paper
• Exclusive paper: Thick paper (weighing 24-1/4 lb to 41-3/4 lb), OHP transparencies, translucent
paper
◆
Paper Size
• Max. Size : 11-3/4×17
• Minimum Size : 4×5-3/4
◆
Capacity of the Multi Bypass Tray
•Plainpaper,recycledpaper .................................Upto50sheets
•Plainpaper(once-copiedpaper) .............................Upto20sheets
• Exclusive paper: Thick paper, OHP transparencies, translucent paper. Up to 20 sheets
Place the original on the Original Glass and
make the control panel settings.
Swing down the Bypass Tray and insert a
neat stack of paper into the tray until it stops.
* Slide the Tray Extender out when using
large-size paper.
Slide the Paper Guide Plate to the size of the
paper.
NOTES
• The paper should be loaded no higher than the
▼
(Max. Level Indicator).
• When loading OHP transparencies or
translucent paper, fan the paper stack well.
• When loading thick paper, be sure first to
eliminate any curl in the paper.
• The paper will be copied on the side facing up.
Paper that Can be Used for Manual Bypass
Using the Intelligent Multi Bypass
Tray
1
2
4002O134AC
3
4002O135AC
To Next Page
Loading...
