Minolta EP1030 - Transport and Bypass Misfeed Clearing; Transport Misfeed Clearing Procedure

ePaper is not
taken up atall.
stationary at
the Transport
4
Does the paper belng used Instruct the user to use the
meet product specifications? paper that meets product
specifications.
Is the paper curled, waved, or Change the paper. Instruct
damp? the user in how to store the
paper.
Is the Paper Take-Up Roll Clean or change the Paper
deformed, worn, or dirty with Take-Up Roll
paper dust? re
Check Paper Take-Up Solenoid ee |
SL2. YES
Does the voltage across PJ6A-2
on PWB-A and GND change Change PWB-A.
from DC24V to DCOV when the :
Start key Is pressed?
Are the Transport Rollers
deformed, wom, or dirty with
paper dust?
Does the voltage across PJSA-2 Check the PC2 actuator for
on PWB-A and GND change operation and, If it checks
from DCSV to DCOV when okay, change PC2.
Paper Transport Sensor PC2 is
blocked?
Clean or change the Paper
Take-Up Rofl.
1&aSBT020202A
2) Transport Misfeed
Relevant Electrical Parts
© Paper Transport Sensor (PC2) © Registration Clutch (CL1)
@ High Voltage Unit (HV1)
; j @ Master Board (PWB-A)
{CLi ON [DCoV |
LCL1 OFF [DE24y|
11S9CO2TAA