Minolta EP1030 - Page 102

@ Paper is
not taken
up at all.
Does the paper being used meet
product specifications?
Is the paper curled, waved, or
damp?
paper dust?
PWB-A and GND change from
DCS5V to DCOV when Paper
Solenoid SL3.
PWB-A and GND change from
is pressed?
Instruct the user to use the
paper that meets product
Change the paper. Instruct
the user in how to store the
Clean or change the Multi
Bypass Paper Take-Up Roll.
Is the Multi Bypass Paper Take-Up
Roll deformed, worn, or dirty with
Check the PC2 actuator for
operation and, if It checks
Does the voltage across PJ3A-2 on
okay, change PC2.
Take-Up Sensor PC2 is blocked?
Check Multi Bypass Paper Take-Up
Change SL3.
YES
| x0 | Change PWB-A.
Does the voltage across PJ5A-2 on
DC24V to DCOV when the Start key
1159SBT020204A
4) Exit Misfeed
Relevant Electrical Parts
@ Paper Exit Sensor (PC3) @ Master Board (PWB-A)
it fait io 9 ——7 1}
[PC3 Blocked|OCoy]
[PC3 Wot Blocked/DC5y|
T159CO4TAA
T-10