Minolta EP1030 - SDH Misfeed Clearing Procedure

@Exit Misfeed Clearing Procedure
| Symptom | Step | ___—Checkitem | Result | Action
Paper Is , | Are the Fusing Rollers dirty or ves | Clean or change the Fusing
scratched? Rollers.
stationary at
ti Are the Fusing Rolier Paper Clean or change the
One: Separator Fingers deformed, YES | defective paper separator
worn, or dirty? fingers.
Is the Cleaning Roller dirty or YES Clean or change the
scratched? Cleaning Roller.
Does the voltage across Change PWB-A.
PJ7A-10 on PWB-A and GND
Check the PC3 actuator for
change from DCSV to DCOV : :
when Paper Exit Sensor PC3 is operation and, if it checks
okay, change PCS.
Paper is
stationary at
the Exit Roller. .
blocked?
T-11
1158SBT020205B
5) SDH Misfeed (EP1030F/EP1031F)
Relevant Electrical Parts
@ SDH Paper Transport Sensor (PC23)
@ SDH Original Set Sensor (P-C22)
@ SOH Paper Take-Up Solenoid (SL10)
@ SDH Drive Motor (M10)
@ SOH Registration Clutch (CL10)
@ SDH PWB (PWB-C)
© Master Board (PWB-A)
®@ SDH Orginal Exit Sensor (PC24)
1159CO5TAB
T-12