Minolta EP1030 - Page 14

(10) Winding of the Scanner Drive Cable
@ Remark
Whenever Scanner Drive Cable has been rewound, be sure to make the “Adjustment of the Scanner/Mirrors
Carriage Position.” See p.D-67,
1159D07BAA
1159D079AC
1159D080AA
1159D077AA,
From the bead on the rear pulley, wrap the shorter of the
Cable counterclockwise four times towards the rear.
Wrap the longer of the Cable clockwise three times to-
warde the front and secure with the Tapo.
From the bead on the front pulley, wrap the longer of the
Cable In clockwise three times towards the front.
D-20
1159D082AC
1159D083AA
1159D084AA
1159D085AA
8
Wrap the shorter of the Cable in counterclockwise four
times towards the rear and secure with the Tape.
Mount the front and rear Cable Drive Pulleys, Drive Belt
Pulley and Pulley Shaft.
install the three set screws to the front and rear Cable
Drive Pulleys and the Drive Belt Pulley and mount the one
E-ring to the Pulley Shaft.
Wrap the shorter of the two Cable in the rear around
Pulley B and secure It to the frame.
Pull the longer of the two Cable and wrap It around
Pulleys A and B.
Wrap the shorter of the two Cable in the front around
Pulley B and secure it to the frame.
D-21