Minolta EP1030 - Adjustments and Calibration; Adjustment Requirements List; Accessing the Tech. Rep. Mode

|
|
|
1159SBD0302A, | 1159SBD0303A i
3-3. ACCESSING THE TECH. REP. MODE
1. Perform the following steps to set the copier in to Service Mode.
| aaa Ie ema oatar Jap [ Seca Tap
=» Exposure Control Key (>)
3-2. ADJUSTMENT REQUIREMENTS LIST
Been CMa eeu Over No. 1 and covering No. 2
Mode (KGS)
fsteeeemma™ | ferenfo
Achgenyclzcom atointe | iio9%)200 2 10mm | Contoipanel | 0-1 |
ctcunbpenae” [oom som [Pm [os
corel ec Sis with
m6 (ty T1B9DOO2AA
Press the Keys in order of [1], [2], [3], Set the Display Panel to a flashing “d”.
and [4]. ;
2.. Use the Copy Quantity and Zoom Key to select the Service Mode No. forthe setting tobe performed
and press the Start Key. (Display will appear in sequence d, c, A, F)
=
Leading Edge Registration in Full
Size Mode
(100 %) 20 + 1.5 mm (Cassette
Section) Control panel
(100 %) 20 + 2.0 mm (Manual pane
Bypass Section)
Leading Edge Registration in En- -
largement Mode (*1) (156 %) 31.2 + 2.4mm Control panel D-57
Leading Edge Registration in Re- (64%) 12.8 + 1.2mm jose.
duction
Mode
(*1)
Contro!
panel
1189D002AA 1159D003AA
Adjustment of the Image Leadin F
oe Sema Wa 9 | (100 %) 3.5 + 0.5 mm Control panel Display Tech. Rep. Choice
Adjusting Screw for
Edge Erase Lamp
Position
Mounting Screw on
(100 %) 20 + 2.0mm the upper SDH cov-
: er.
Adjusting the Leading Edge Reg-
istration (*2) (100 %) 20 + 2.0mm Control panel
Adjustment of SDH Center Align- : _ Mounting Screw on
ment (*2) Width B-WidthA= 1.0mm | 14 46 of SDH D-67
Adjustment of Edge Erase (*1) Width B ~ Width A= 4 1.0mm
Adjusting the SDH Reference
Position (*2)
«
1159D004AA V159D005AA
Test Adjust
*{: EP1031/EP1031F Only :
*2: EP1030F/EP1031F Only
D-40 | D-41