Minolta EP1030 - Leading Edge Registration Adjustments; Leading Edge Registration in Full Size Mode; Leading Edge Registration in Enlargement Mode (EP1031;EP1031 F Only)

4. Set to Service Mode. (10)-2, Leading Edge Registration in Enlargement Mode
5. To adjust the A3 Full Size Registration, press the following keys in the indicated sequence: Copy
Quantity and Zoom Key © two times; the Start Key one time and the Copy Quantity and Zoom Key
@ three times.
1. Once the 1:1 Zoom Registration has been adjusted, make
one copy using A4 or 8-1/2” x 14” paper ata x 1.56 en-
largement ratio.
2. Ifthe registration Is up to the specifications, go to the ad-
justmentin the reduction mode. Ifit deviates from the spec-
ifications, perform the following steps to make the adjust-
ment of. leading edge registration in the enlargement
mode.
1159D022AA
: Press the Keys in order of [1], [2], [3]. “A3” will appear In the Display Panel.
[4], [5], and [6]. | ’ @ This adjustment should be made after the “adjustment of leading edge registration in the full size
, mode”.
wey 6. Press the Start Key to change the settings for the Full Size Registration. ' :
a Press the Clear/Stop Key to set the settings. i 3. Set to Service Mode.
4. To adjust the A4 Enlargement Registration, press the following keys In the indicated sequence: Copy
Quantity and Zoom Key © two times; the Start Key one time and the Copy Quantity and Zoom Key
© four times.
Setting Instructions
@ If diméntion A on the copy is longer than 21.5 mm, increase the setting value.
@ |f dimention A on the copy is Shorter than 18.5 mm, decrease the setting value.
* If the measurement does not fall within the specifications through one setting, try another setting.
11590026AA
Press the Keys in order of [1], [2], [3], “A4’ will appear In the Display Panel.
[4], {S], [6], and [7].
Touch This Key if
Measurement is Longer.
Touch This Keyif 1159D024AA
Measurement Is Shorter.
8. After the adjustments have been made, press the Clear/Stop Key to restore the copier to the normal
| copy mode.
|
D-56
:
D-57