Minolta EP1030 - Image Erase Width Adjustment; Adjustment of the Image Leading Edge Erase Width

5.
Press
the
Start
Key
to
and
use
the
Copy
Quantity
and
Zoom
Keys
to
change
the
settings
for the
Reduc-
tlon
Registration
Adjustment.
6.
Press
the
Clear/Stop
Key
to
set
the
settings.
Setting Instructions
© If dimention A on the copy is longer than 14 mm, increase the setting value.
© If dimention A on the copy is Shorter than 16 mm, decrease the setting value.
* Ifthe measurement does not fall within the specifications through one setting, try another setting.
Touch This Key If
Measurement is Longer.
Touch This Key ff 1159D024AA
Measurement Is Shorter.
7.
After
the
adjustments
have
been
made,
press
the
Clear/Stop
Key
three
times
to
restore
the
copier
to
the
normal
copy
mode.
D-60
(11) Adjustment of the Image Leading Edge Erase Width
@ Requirement
@ As shown in the illustration on the left, use a A4 test chart
or a sheet of 8-1/2” x 14” paper to draw black mark 20
approximately 20 mm from the center section of the lead-
ing edge. Adjust so that this black mark will image erase
3.0 to 4.0 mm from the leading edge.
@ Specification .............45 3.5 + 0.5mm
5 riGAGy ® Adjustment Setting Range .... 38 to 68
@ Important
@ This adjustment should be made after the “adjustment of the leading edge registration’.
1. Place the test chart on the reference position for the origi-
nal Width scale and close the Original Cover.
2. Make a one copy using A4 or 8-1/2” « 14” paper at a 1:1
zoom ratio.
3. Ifthe erase width deviates from the specifications, perform
the following steps to make the adjustment of image lead-
Ing edge erase width.
1159D148AA
4, Set to Service Mode.
5. Toadjustthe AA Leading Edge Erase Width, press the following keys in the indicated sequence: Copy
Quantity and Zoom Key @ two times; the Start Key one time and the Copy Quantity and Zoom Key
@ seven times.
pam
pire
1159D030AA
Press the Keys in order of [1], [2], [3],
[4], (5], (6], [7], [8], [9], and {10}.
“AA” will appear in the Display Panel.
D-61