Minolta EP1030 - Exterior Part Removal

1156SBD0200A
ea DISASSEMBLY/REASSEMBLY
115988D0201A
2-1. DOORS, COVERS, AND EXTERIOR PARTS: IDENTIFICATION AND
REMOVAL PROCEDURES
1159D034AA
1159D035AA,
Front Door
Middle Front Cover
Pull out the Paper Feed Cabinet
Swing down No. 1. + Release and swing up the Upper Half
of the copier. + Remove two screws that secure the Upper
Rear Cover.
[a Swing down No. 1. + Open Front door to the right and re-
up the Upper Half of the copier. + Remove two screws that
secure the Middle Front Cover.
Upper Front Left Cover of the copier. + Remove No. 15. + Remove two screws that
secure the Upper Front Left Cover.
bee Original Scales Swing down No. 1. + Release and swing up the Upper Half
za Upper Right Cover Remove two screws that secure the Upper Right Cover.
, Swing down No. 1.—+ Remove No. 11. ++ Remove two
eel Middle Right Cover screws that secure the Middle Right Cover.
Open No. 11. -+ Ramove No. 9. -+ Remove two screws that
secure the Right Door.
Door.
Pape Feed Cabinet
j 1 [recom
move from the right side.
gi | Control Pane! Remove two screws that secura the Control Panel.
| 6 | Original Glass of the copier. + Remove No. 15. + Remove No. 4. -+ Re-
Manual Bypass Table Remove two screws that secure the Manual Bypass Table,
<EP1030/EP1030F>
SDH (*1)
Pull out No. 12. + Swing down No. 1. —+ Release and swing
Swing down No. 1. + Release and swing up the Upper Half
SDH Glass (*1) move two screws that secure the Original width Scales.
<EP1031/EP1031F>
1 Right Door
Remove No. 9. + Remove two screws that secure the Right
14
Original Cover (*2)
Open the Original Cover + Remove the Hinge.
Swing down No. 1, + Release and swing up the Upper Half
of the copier. -+ Remove four screws that secure the Upper
Left Cover.
Upper Left Cover
Remove No, 17.
Exit Cover
Swing down No. 1. -++ Release and swing up the Upper Half
of the copier. + Remove three screws that secure the
Middle Rear Left Cover.
Middle Rear Left Cover
*1 : EP1030F/EP1031F only
*2: EP1030/EP1031 only
D-7