Minolta IIIF - Page 7

Over-/Under-Range Indications
OVER/UNDER MEASURING RANGE
The meter’s measuring range is EV3 to EV16.3 in AMBI measuring mode and f/2.8 to f/180 (at the
meter position) in CORD or NON.C measuring mode. If the illuminance is over or under this range,
D or W will blink respectively (Display-mode indications will not blink).
"If À blinks:
* H W blinks:
Over measuring range Under measuring range
LB
FILTER [CORD]
CC
aly
TIME 3 Hi A+
in AMBI measuring mode, move away from the light source and take another
measurement.
in CORD or NON.C measuring mode with the flash-range switch set to Lo, set
the flash-range switch to Hi and take another measurement.
If the indication continues to blink, move away from the flash and take another
measurement.
In AMBI measuring mode, move closer to the light source and take another
measurement.
In CORD or NON.C measuring mode with the flash-range switch set to Hi, set
the flash-range switch to Lo and take another measurement.
If the indication continues to blink, move closer to the flash and take another
measurement.