2. Initial Settings
7-7
Miscellaneous
Chapter 7
Entering and Leaving the User Mode
1
Hold down the Shift key and Output Selection key at the same time for 0.5 sec.
The Multi-Print Display displays a “U.”
O
u
t
pu
t
S
e
l
e
c
t
i
on
S
h
i
ft
U
s
e
r
M
od
e
2
Press the Exposure Adjustment key (Darker or Lighter) to select the specific function.
D
a
r
k
e
r
Pressing the Darker key selects the function in the following order: U → U1
→ U2 → U3 .. → U8.
L
i
gh
t
e
r
Pressing the Lighter key selects the function in the following order: U8 → U7
→ U6 → U5 .. → U.
3
Press the Exposure Mode key to display d(*).
*: Current setting value
A
u
t
o
Z
oo
m
c
l
r
4
Press the Exposure Adjustment key (Darker or Lighter) to select the specific setting
value.
D
a
r
k
e
r
Pressing the Darker key selects the setting value in the following order: d0 →
d1 ..
L
i
gh
t
e
r
Pressing the Lighter key selects the setting value in the following order: d5 →
d4 .... d0
5
Press the Start key to validate the setting value.
S
t
a
r
t
If the Exposure Mode key is pressed, the setting value is not validated and the User
mode initial screen (U) appears.
If a new function is to be set, start the procedure over beginning with step 2.
6
Press the Clear key.
This lets you leave the User mode, returning back to the ordinary mode.
To Next Page
Loading...