18. Using the Cycle Print Mode
2-35
Scanner
Chapter 2
Operating in the Cycle Print Mode
1
After entering the Cycle Print Mode,
press the Start key to start.
Start
NOTE
• After the first scanning operation has
finished, the system will automatically
scan the next image following a preset
period of time. The system will continue
to operate until the Cycle Print Mode is
canceled.
• The “No. of Copies” value flashes
during the “scanning” and “waiting”
operations.
• The next scanning job can be started
manually by pressing the Start key
before the system automatically initiates
the same job.
2
To pause an operation during the
Cycle Print Mode, press the Clear key
(the “No. of Copies” value will
switch from a blinking display to a
constant display).
3
While the pause function is enabled,
it is possible to exit the Cycle Print
Mode by pressing the Clear key a
second time (the value displayed in
the “No. of Copies” display will
change to a “1”.)
To Next Page
Loading...