2. Initial Settings
7-8
Miscellaneous
Chapter 7
Settings in Each User Mode Function
U1: Special Print Mode
This function is not available.
U2: Engineering Enhancement Mode
Slight image distortion occurring in the scan direction can be corrected with this function.
Before Correction After Correction
1
Select U2 in the User mode.
2
Press the Exposure Mode key to display d*.
3
Press the Exposure Adjustment key (Darker or Lighter) to select the desired setting
value.
4
Press the Start key to validate the setting value.
NOTE
This setting returns to the default value when the Power Switch is turned OFF.
You can register the setting value using with the Job Program. ☞ See p. 2-38.
Code Setting Value Initial Setting
d0 0mm
d1 0.5mm
d2 1.0mm
d3 1.5mm *
d4 2.0mm
d5 2.5mm
d6 3.0mm
d7 3.5mm
d8 4.0mm
To Next Page
Loading...