3. Control Panel Keys and Indicators
2-14
Scanner
Chapter 2
The Scanner is connected to the PC and ready for scanning by
pressing the Start Key.
This display is blinking when the Scanner is in operation.
The Scanner is not connected to the PC. Turn ON the PC or
connect the Scanner to the PC with the interface cable.
The Projection Lamp is burned out. Replace the lamp.
☞ See p. 2-43.
* If the lamp goes out during a print cycle, a blank print may
be output.
The battery for Date Print has run down.
Turn OFF the Date Print function, or call your Tech. Rep. for
replacement of the battery.
Magnification warning display
Did the modification of the magnification by an electronic
zoom.
Lights up when setting besides the standard magnification.
Code Description
To Next Page
Loading...