EasyManua.ls Logo

Mircom FA-300 Series - Page 80

Mircom FA-300 Series
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
80
Configuration with the CFG-300 LCD Service Tool
11.11.1 Command Menu/Dialer Config-->Account Info
Command Menu/Dialer Config/Account Info
1.Account# 1 Identification
123456->Default
Use this menu to set the
Account ID for the
monitoring station to which
the dialer reports events.
The maximum # of digits
allowed is six. For contact
ID, only the first four digits
are used; the last two are
truncated.
Unless you are using the
SIA protocol, the allowed
digits for the account ID are
simple digits 0 to 9 and
hexadecimal digits A to F
(the SIA protocol only
allows digits 0 to 9).
To enter hexadecimal digits,
press the INFO button. The
letter “A” appears. To scroll
through the rest of the
letters, press INFO
repeatedly. Press # to move
the cursor to the right or
press * to move it to the left.
Command Menu/Dialer Config/Account Info
2.Account#1 Telephone Number
[101]->Default
Use this menu to set the
telephone number of the
monitoring station. The
maximum # of digits allowed
is 19 including “,” and
numerals. The “,” is a 1 sec
delay. To enter “,” press the
INFO button. Press # to
move the cursor to the right
or press * to move it to the
left. An example of a typical
telephone # is 9,,12345678.
1 Account#1 ID
2 Account#1 Tel
3 Accnt#1 Format
4 Account#2 ID
- Account Info -
5 Account#2 Tel
6 Accnt#2 Format
Account#1 ID:
_
Account#1 Telnum:
_

Table of Contents

Other manuals for Mircom FA-300 Series

Related product manuals