TX3 Configurator Software Guide
LT-973 15
Configuring Phone Lines
Lobby Control Units, such as the TX3 Telephone Access and Touch Screen
systems, can call resident using either ADC or NSL telephone lines. Up to
five lines may be configured.
To configure phone lines
1. From the Network tree, select one of your Lobby Control Unit (that
is, either a telephone access panel or a touch screen panel).
2. Select Phone Lines from the Panel Configuration window. The
Phone lines window appears.
3. Provide information for each the following:
Phone lines. Select either ADC or NSL.
Phone lines/Guard phone is connected. Select this check box if a
guard phone unit is currently connected to this panel.
4. Proceed with Creating a Resident Database on page 16.
To Next Page
Loading...
