TX3 Configurator Software Guide
LT-973 7
4. Enter your password to log in to the system and click OK (The
default password is blank). The Main Window appears. You are
now ready to begin configuration. To facilitate configuration, the
previous session displays whenever you log in.
Note: The panel address (ID) in the software must match the address
setting on the panel. Check the SW1 DIP switch settings on the
main board of the Telephone Access panel you are connected
to (SW2 for Card Access). Refer to the TX3 Installation and
Operation Manual for the DIP switch settings.
Connecting Using the USB
The USB is a direct connection from your computer to the entry panel.
To connect to the USB
1. Connect the USB of your PC to the USB connector on the TX3 Entry
Panel board.
2. Click Network. The Network Configuration window appears.
To Next Page
Loading...
