24 LT-973
To get a job
1. Select Get from the Tool Bar. The Get Job from Panels window
appears.
2. Select the required parameters as explained below:
Create a new job. Scans the network for panels and uses their
configuration information to create a new job. The Detect new panels
check box is automatically checked.
Create a new job based on current job. Copies the current job and
creates a new job based on the existing job.
Overwrite current job. The most recent configuration overwrites
the existing information panel information.
Detect new panels. If selected the software scans the network for any
new panels and reads their configurations.
3. Click OK to create a job and return to the configuration window, or
click Cancel to exit without saving the changes.
To Next Page
Loading...
