What to do if Mirion Technologies MBD-2 report exceeding maximum dose?
If your Mirion Technologies Measuring Instruments device reports that one or more detector elements has exceeded the maximum dose, it requires a reset of the device. Remove the device from service.
Why does my Mirion Technologies Measuring Instruments device not read in hot temperatures?
If your Mirion Technologies Measuring Instruments device is not reading and the operating temperature is above +50°C, the read-out process is not performed. Move the device to a cooler environment.
Why does my Mirion Technologies MBD-2 device not read in cold temperatures?
If your Mirion Technologies Measuring Instruments device is not reading and the operating temperature is below -10°C, the read-out process is not performed. Move the device to a warmer environment, such as a pocket or inside layers of clothing. Once the temperature stabilizes, the 'Lo.t' message will disappear.
What does it mean if my Mirion Technologies MBD-2 device is displaying 'Err' continuously?
If your Mirion Technologies Measuring Instruments device displays 'Err' continuously, it means that after a system reset, the result memory was inaccessible, and the device repeatedly reset itself. Since no element measurement was successful before three self-resets, the reset operation was disabled. Remove the device from service.
What to do if Mirion Technologies Measuring Instruments report an error due to AD converter?
If your Mirion Technologies Measuring Instruments device reports an error due to the AD converter not completing internal readout conversion, remove the device from service for analysis. If the error occurs only in cold environments, report this so the device configuration can be modified to prevent recurrence.
What to do if Mirion Technologies Measuring Instruments detect maximum voltage in the input line?
If your Mirion Technologies Measuring Instruments device reports an error indicating that the AD converter has detected maximum voltage in the input line, remove the device from service.
What to do if Mirion Technologies MBD-2 Measuring Instruments show parameter error?
If your Mirion Technologies Measuring Instruments device shows a Parameter Error, remove the device from service and return it for Warranty Repair.
What to do if the Mirion Technologies MBD-2 device restarts after a battery change?
If your Mirion Technologies Measuring Instruments device restarts after a battery change, it indicates that internal data memory was found to be corrupt, and the device performed a self-hard reset to clean the memory. If this error message occurs under normal use (without high dose or neutron exposure), remove the device from service.
What does it mean if my Mirion Technologies Measuring Instruments display 'dbAt'?
If 'dbAt' is cycling on the display of your Mirion Technologies Measuring Instruments, it means less than 25% battery life remains. If 'dbAt' is permanently displayed, the battery is exhausted. In both cases, replace the batteries with 3 new CR1025 batteries.
General| Brand | Mirion Technologies |
|---|---|
| Model | MBD-2 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
