OpenPhone 27 Handset User Guide
Page 17
1. Short press .
2. Press
to select Local Mode.
3. Press OK.
4. Press
to select Ringer Settings.
5. Press OK.
6. Set the following parameters:
- Melody – choose from 30 melodies
- Type – select type of notification: full melody, single bar, or chirp
- Device – buzzer or vibrator
- Volume – set volume for internal calls, external calls, VIP calls, and messages
A check mark (
) appears next to the activated setting.
7. Press Esc to exit Local Mode menu.
Setting Your Name
If your name hasn’t been programmed to appear on your handset display by your System
Administrator, you can program it yourself using the following procedure.
To set your name:
1. Short press
.
2. Press
to select Local Mode.
3. Press OK.
4. Press
to select Telephone Option.
5. Press OK.
6. Press
to select User Name.
7. Enter your name using the keypad keys (maximum of 16 characters).
- For each letter in the name, press the appropriate key on the keypad until the letter is
shown in the display; for example, if the letter C is required, press the digit 2 three
times. Use the
softkeys to move the cursor. If the next letter in a name is on the
same key as the previous letter, press the softkey before proceeding. To delete a
letter, press
. To insert a space, press 0 twice.
- Long key press for the character within the editor switches from capitals to non-capitals
(same action switches back).
8. Press Esc.
To Next Page
Loading...
