16
Telephones that are not programmed for full-time headset operation should be
programmed with a HEADSET feature key to allow you to switch between
handset and amplified headset (no feature control switch) operation.
Switching between handset and headset mode when using a Headset with Feature
Control Switch can be accomplished by connecting or disconnecting the headset at
the quick-disconnect plug on the headset cord, but you should also disable headset
operation if the handset will be used for an extended period of time.
A headset can be used either in regular answer mode or with the Auto Answer
feature programmed.
Most headsets are installed using the same jack that the handset plugs into. Mitel
Headsets with Feature Control Switch (PN 9132-800-500-NA/9132-800-501-NA)
plugs into the dedicated headset jack (the jack nearest the front of the set).
Installing a Headset (no Feature Control Switch)
To install the headset for your use
1. When the telephone is not in use, lift the handset from the cradle and
carefully turn the set upside down.
2. Unplug the handset cord where it connects to the telephone.
3. Plug in the headset cord in the same place.
4. Set the telephone upright and return the handset to the cradle
5. Press the Headset Feature Key.
6. Store your handset in a safe place.
To return to handset operation
1. When the telephone is not in use, lift the handset from the cradle and
carefully turn the set upside down.
2. Unplug the headset cord where it connects to the telephone.
3. Plug in the handset cord in the same place.
4. Set the telephone upright and return the handset to the cradle.
5. Press the Headset Feature Key.
6. Store your headset in a safe place.
To Next Page
Loading...
Need help?
Processor and Memory
Weight and Dimensions
