Mitsubishi Electric AJ65BT-D62 - Page 103

MELSEC-
A
10. PROGRAMMING
10 - 25
Coincidence signal reset
Pulse count stop
CH.1 point No. 1
coincidence signal reset
command (RY10) is ON.
CH.1 point No. 1
coincidence signal reset
command (RY10) is OFF.
CH. 1 coincidence output
enable (RY12) is OFF.
CH.1 count enable
(RY14) is OFF.
Coincidence signal reset
Coincidence output reset
Stop of counting
Downloaded from ManualsNet.com search engine