Mitsubishi Electric AJ65BT-D62 - Page 129

MELSEC-
A
10. PROGRAMMING
10 - 51
Current value reading
Current value
reading
Latch count value reading
Latch counter command
Execution of latch counter
Execution of latch counter
Pulse count stop
Stop of counting
Remote output signal write
CH.1 current value
(RWr0, RWr1) is read.
CH.1 latch count value
(RWr2, RWr3) is read.
CH.1 counter function
selection start command
(RY16) is ON.
CH.1 counter function
selection start command
(RY16) is OFF.
CH.1 count enable
(RY14) is OFF.
RY00 to RY7F is written
to Y400 to Y47F.
Downloaded from ManualsNet.com search engine