Mitsubishi Electric AJ65BT-D62 - Page 131

MELSEC-
A
10. PROGRAMMING
10 - 53
Sampling time set
Sampling time set
Sampling count value reading
Count value reading
Execution of sampling counter function
Execution of sampling counter
Pulse count stop
Stop of counting
Remote output signal write
CH.1 sampling time set
(RWw5): 20000 ms
Write to master station.
CH.1 sampling count
value (RWr2, RWr3) is
read.
CH.1 counter function
selection start command
(RY16) is ON.
CH.1 counter function
selection start command
(RY16) is OFF.
CH.1 count enable
(RY14) is OFF.
RY00 to RY7F is written
to Y400 to Y47F.
Downloaded from ManualsNet.com search engine