A - 4
[Starting and Maintenance Precautions]
CAUTION
Do not touch the terminals while the power is on.
Doing so may cause malfunction.
Do not drop or apply strong shock to the module.
Failure to do so may damage the module.
Do not disassemble or modify the module.
This can cause a failure, misoperation, injury or fire.
The module case is made of resin. Do not drop it or give it hard impact.
This can damage the module.
Be sure to shut off all phases of the external power supply used by the system before mounting
or dismounting the module to or from the panel.
Not doing so can cause the module to fail or malfunction.
Do not install/remove the terminal block more than 50 times after the first use of the product.
(IEC 61131-2 compliant)
Before handling the module, always touch grounded metal, etc. to discharge static electricity
from the human body.
Failure to do so can cause the module to fail or malfunction.
The pulse/external input voltage setting pins must be set after switching power off externally in
all phases.
Otherwise, the module can fail or misoperate.
[Precautions Regarding Product Disposal ]
CAUTION
When disposing of the product, handle it as industrial waste.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
