M800W/M80W Series Connection and Setup Manual
21 Setting Up with HMI Integrated Installer
445
IB-1501268-K
21.3 Operation Methods
The following shows how to install the applications.
(1) Prepare the memory card which contains the installation environment for "custom release applications". Insert the
memory card into the memory card interface on front of the display unit.
(2) Enter the password on the Mainte screen.
(a) On the Mainte screen, select [Mainte] and then [Psswd input].
(b) Enter the machine parameter password in the setting area and press the [INPUT] key.
(3) Select [HMI verup] on the Mainte screen. The [HMI verup] menu will be highlighted, and a message will appear to
confirm the PLC stop.
(4) Press [Y] or the [INPUT] key. After PLC is stopped, HMI integrated installer will start and the screen will appear.
When the memory card contains the installation environment for "custom release applications", names of the
applications that can be installed will be displayed in the application list.
(5) Select an application to install from the displayed application list.
(6) Select [Install start]. The [Install start] menu will be highlighted, and a message will appear to confirm the application
installation. The [Y] button shows selected.
(Note) If no application has been selected before the [Install start] menu is selected, an error message will
appear and the [Install start] menu will be unhighlighted.
(7) Press the [INPUT] key. Or touch the [Y] button which shows selected.
The installation of the selected application will be started.
(Note 1) If no USB keyboard is connected to the 19-type display unit, the display shows a screen keyboard. Use
this keyboard for key operation.
(Note 2) When the [N] button or another menu is touched, the [Install start] menu will be unhighlighted and the
application will not be installed.
(Note 3) While installing, all menus will be grayed out and cannot be selected.
(Note 4) All tasks except the system-related are quitted immediately before the installation of the selected
application. Quit all unnecessary tasks before starting the integrated installer.
(8) After the application has been installed, turn the power ON and OFF.
To Next Page
Loading...
Need help?
General
