Mitsubishi Electric M800W Series User Manual

M800W/M80W Series Connection and Setup Manual
23 Sequence Program Writing
470
IB-1501268-K
23.9.3 Setting Common Pointer No.
Set the pointer No. common to sequence programs when creating sequence programs in multi-program method. This
operation is required every time a new project is created, and parameter files must be written to the CNC controller.
(Note) When not set, Common Pointer No. is set as P1800.
When a simple project (with labels) or a structured project is newly created, or when "Project Type" is changed
to any of the said project, "2048" is automatically set to "Common Pointer No." as the default value if its setting
has been blank.
(1) Select the PLC System tab.
(2) Set a numeric value in [Common Pointer No.], and click [End] on the following screen.

Mitsubishi Electric M800W Series Specifications

General

Number of control axes	Up to 8 axes
High-speed processing	Yes
Positioning control	Yes
Synchronized control	Yes
Spindle control	Yes
Operating Temperature	0 to 45°C
Storage Temperature	-20 to 60°C
Control Method	Digital Servo Control
Display	15-inch LCD
Communication interfaces	Ethernet, RS-232
Power Supply	AC 200 to 240V
Type	CNC Control System