Mitsubishi Electric MELSEC iQ-R Series - Page 67

5 SAFETY APPLICATION CONFIGURATION EXAMPLES
5.1 System Configured by a Safety CPU
65
5
Application settings
Set the supplementary cyclic settings, safety communication settings, and other parameters of the CC-Link IE Field Network
master/local module. Display the application settings. Then, select and input parameters as shown below. Complete the input.
Then, click the [Apply] button in the lower right of the window. When setting "Safety Function Setting", double-click a line of
the safety function setting in item window, or click the right-side button to be displayed when selecting line.
Window
Displayed items
Setting classifications CCIEF master (1)
Application Settings Supplementary Cyclic Settings Refer to Supplementary Cyclic Settings.
Interrupt settings Do not set.
IP Address Do not set.
Communication mode Normal
Parameter name (Blank)
Dynamic Routing Enable
Event reception from other stations Enable
Module operation mode Online
Interlink transmission settings Do not set.
Setting of safety communication use or not Use
Safety Communication Setting Refer to Safety Communication Setting.