Mitsubishi ASX 2016

NOTE
l
If a problem is detected in the air condition-
ing system, the air conditioning operation in-
dication lamp (A) blinks. Press the air condi-
tioning switch once to turn it off, then once
more to turn it back on. If the air condition-
ing operation indication lamp does not blink
for a while, there is nothing wrong. If it
starts to blink again, we recommend you to
have it checked.
l
Sometimes, for example after using a high-
pressure car wash, the condenser can get
wet, and the operation indication lamp (A)
blinks temporarily. In this case there is noth-
ing wrong. Wait a while, press the air condi-
tioning switch once to turn the system off,
then once more to turn it back on. Once the
water evaporates, the blinking will stop.
Customizing the air condition-
ing switch (Automatic air condi-
tioning)
E00764700030
Functions can be changed as desired, as sta-
ted below.
l
Enable automatic air conditioning con-
trol:
If the mode selection dial or blower
speed selection dial is turned to the
“AUTO” position, or the temperature
control dial is set to the minimum tem-
perature, the air conditioning switch is
controlled automatically.
l
Disable automatic air conditioning con-
trol:
The air conditioning switch is not con-
trolled automatically as long as the air
conditioning switch is not operated.
l
Setting change method
Hold down the air conditioning switch
for about 10 seconds or more.
When the setting is changed, a sound is
emitted and the indication lamp flashes.
• When the setting is changed from ena-
ble to disable 3 sounds are emitted and
the indication lamp flashes 3 times.
• When the setting is changed from dis-
able to enable 2 sounds are emitted
and the indication lamp flashes 3
times.
NOTE
l
The factory setting is “Enable automatic air
conditioning control”.
l
When you turn the mode selection dial to
“ ”, in order to prevent misting of the
windows the air conditioning operates auto-
matically even if “Disable automatic air con-
ditioning control” is set.
Operating the air conditioning
system
E00701800436
Heating (Heater/Manual air
conditioning)
Set the mode selection dial to the “ ” posi-
tion and set the air selection switch (A) to the
outside position.
Turn the temperature control dial clockwise
or anticlockwise to the desired temperature.
Select the desired blower speed.
NOTE
l
For quick heating, set the blower speed se-
lection dial to the position shown in the il-
lustration.
Heater/Air conditioning
7-07
OGAE15E5
For pleasant driving
7