Using the remote control to operate VCRs, cable
boxes and other components (cont.)
using your remote control to operate your Mitsubishi I)VD
player or laserdisc player
After you have set up your remote control for your DVD player or
laserdisc player, you can use the remote to operate the player.
O Use the select switch on the remote control to choose the ]ayer
that you set up to operate your laserdisc player: DVD.
O Point the remote at the DVD player or laserdisc player and press
the desired buttons.
You can use the POWER, CHANNEL, numbers (0-9) (for laserdisc
player only), INFO, MENU, CANCEL, STOP, PAUSE, REW, PLAY,
and FF buttons to operate your DVD player or laserdisc player.
using your remote control to operate your Mitsubislhi audio
products
After you have set up your remote control for your A/V receiver, you
can use the remote to operate it.
Use the select switch on the remote control _;ochoose the ]ayer
that you set up to operate :your receiver: TV DVD, or AUDIO.
Point the remote control at the A/V receiver and press the
desired buttons.
If you are using a Mitsubishi HTS-100, you can use the POWER,
VOLUME, and MUTE buttons to operate tlhe receiver.
If you are using a Mitsubishi HTS-300, you can use the POWER,
CHANNEL, INPUT, VOLUME, ENTER, nuraber (0-9), INFO,
MENU, CANCEL, AUDIO, VIDEO.. ADJUST, and MUTE buttons to
operate the receiver.
If you are using a Mitsubishi M-VR400, M-VR6()0, M-VR800 or
M-VR1000, you can use the POWER, VOLU-ME: 0-9, and MU'rE
buttons to operate the receiver. The ADJUST buttons will access the
M-VR800/1000 menus.
If you are using the Mitsubishi M-CD500 CD player, you can use the
PAUSE, STOP, FF, and REW buttons to operate the CD player.
PRIMESTAR ®is a registered servicemark of PRIMESTAR Partn:ers LP.
Getting Started 43
To Next Page
Loading...
Need help?
General
