EasyManuals Logo

Mitsubishi CK-36310 User Manual

Mitsubishi CK-36310
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
Using the remote control to operate VCRs, cable
boxes and other components (cont.)
_Important:
_Important:
notes about your remote control
Sometimes manufacturers will change their products, or they r;Lay
use more than one code. If this is the case, your remote may not be
able to operate your VCR or cable box.
When you replace the batteries in your remote control, the remote
will usually return to its initial setting. You may need to set up your
remote again.
resetting the layer of your remote to the original factory
setting
O Turn off the power of the component you wish to reset.
O Set the select switch to choose the layer you have set the
component to.
While holding in the POWER button on the remote, enter the
code 00.
Release the POWER button.
using your remote control to operate your VCR
After you have set up your remote control for your particular brand
of VCR, you can use the remote to operate your VCR.
O Use the select switch on the remote control to choose the layer
that you set up to operate your VCR: VCR or DVD.
Point the remote at the VCR and press the desired buttons.
If you are using a Mitsubishi VCR, you will be able to use all ,_f the
buttons on the remote to operate your VCR except for MUTE, VOL-
UME, and the PIP function buttons, which will always operate tlhe TV
itself.
If you are using another brand of VCR, you can use the POWER,
CHANNEL, REC, STOP, PAUSE, REW, PLAY, and FF buttons to
operate your VCR.
using your remote control to operate your cable/satel[lite box
After you have set up your remote control for your particular brand of
cable/satellite box, you can use the remote to operate it.
O Use the select switch on the remote to choose the layer that you
set up to operate your cable/satellite box: DVD or AUDIO.
Point the remote at the box and press the desired buttons.
You can use the POWER, CHANNEL, numbers (0-9), and ENTER
buttons to operate your cable box. If you are using an RCA DSS or
PRIMESTAR ®receiver, you may be able to use additional buttons.
42 Chapter 3: Operating Your TV

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi CK-36310 and is the answer not in the manual?

Mitsubishi CK-36310 Specifications

General IconGeneral
BrandMitsubishi
ModelCK-36310
CategoryTV
LanguageEnglish

Related product manuals