Using the remote control to operate VCRs, cable
boxes and other components (cont.)
0
[_Important:
Press the POWER button again. Your cable/satelLite box should
turn off. If the cable/satellite box turns off, your remote control is
now set up to operate your cable/satellite box. If your cable/satellite
box does not turn off, repeat the instructions above, trying each code
number listed for your brand of cable/satellite box. If none of these
numbers work, try each number, 51 through 99.
Some of the boxes can be turned on with the CI_NNEL buttons or
the number buttons instead of the POWER button.
setting up the remote control to operate your Mitsubishi
components (DVD player, laserdisc player cr A/V receiver)
O Turn off your component.
O
Set the select switch on the top of the remote to choose the layer
you want to set up. For a laser disc player, choose DVD. For a
DVD player, choose VCR, DVD or AUDIO. For an A/V receiver,
choose DVD or AUDIO.
While holding in the POWER button on the remote contro!,
enter one of these code numbers:
• For a Mitsubishi AN receiver and compact disc player:
30, 31, 35 or 38
• For a Mitsubishi laserdisc player: 32 or 33
• For a Mitsubishi DVD player: 34
• For a Yamaha A/V receiver and compact disc player: 36 or 37
Be sure to enter both digits of the code number. If more than
one number is listed, begin with the first one.
0 Release the POWER button.
0
Press the POWER button again. Your component should turn
on. If it does, your remote control is now set nap to operate your
component. If it does not turn on, repeat the instructions above,
trying the other code numbers listed for your component.
(See "using your remote control to operate your Mitsubishii DVD
player or laserdisc player" and "using your remote control to
operate your Mitsubishi A/V receiver" in this chapter for infor-
mation on using the remote to operate your other components.)
Getting Started 41
To Next Page
Loading...
Need help?
General
