Selecting source of the PIP image
0 Turn your VCR on.
O Turn the PIP image on.
O Press the SOURCE button on
the remote control repeatedly
until the VCR picture appears
in the PIP image.
O If you want to select a source
other than the VCR, continue
pressing the SOURCE button.
The source will change as
follow_';:
_TV--_ INPUT-1---_- INPUT-2 -j
_>Important:
_ Important:
To change the main image wlhile a PIP image is displayed, press
the input button (INPUT) on the control panel or on the remote
control.
To see two different channels at the same time, you must:
• connect a second tuning source (such as a VCR) to an input as
shown in the connection diagrams in Chapter 2 of this manual
• use the SOURCE button to select the input for the second tuning
source
86 Chapter 4: Using the Special Features
To Next Page
Loading...