If you are carrying the keyless operation key,
you can start the engine.
CAUTION
l
The indication lamp (A) will flash orange
when there is a problem or malfunction in
the keyless operation system. Never drive if
the indication lamp on the engine switch is
flashing orange. Immediately contact a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
l
If the engine switch operation is not smooth
and feels like it is sticking, do not operate
the switch. Immediately contact a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
NOTE
l
When operating the engine switch, press the
switch all the way in. If the switch is not
fully pressed, the engine may not start or the
operation mode may not change. If the en-
gine switch is pressed correctly, there is no
need to hold the engine switch down.
l
When the battery in the keyless operation
key has worn out, or the keyless operation
key is out of the vehicle, a warning display
will appear.
Warning display (when the engine switch is
pressed one time)
Warning display (when the engine switch is
pressed two times or more)
Operation mode of the engine
switch and its function
OFF
The indication lamp on the engine switch
turns off.
The operation mode cannot be put in OFF
when the selector lever is in any position oth-
er than the “P” (PARK) position (CVT).
ACC
Electrical devices such as the audio and ac-
cessory socket can be operated.
The indication lamp on the engine switch il-
luminates orange.
ON
All vehicle’s electrical devices can be operat-
ed.
The indication lamp on the engine switch il-
luminates green. The indication lamp goes
off when the engine is running.
NOTE
l
Your vehicle is equipped with an electronic
immobilizer.
To start the engine, the ID code transmitted
by the transponder inside the key must
match the code registered in the immobilizer
computer. Refer to “Electronic immobilizer
(Anti-theft starting system)” on page 3-03.
Engine switch*
6-15
OGKE18E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
