Changing the operation mode
E00631901298
If you press the engine switch without de-
pressing the brake pedal (CVT) or the clutch
pedal (M/T), you can change the operation
mode in the order of OFF, ACC, ON, OFF.
CAUTION
l
When the engine is not running, put the op-
eration mode in OFF. Leaving the operation
mode in ON or ACC for a long time when
the engine is not running may cause the bat-
tery to be discharged, making it impossible
to start the engine, lock and unlock the steer-
ing wheel.
CAUTION
l
When the battery is disconnected, the cur-
rent operation mode is memorized. After re-
connecting the battery, the memorized mode
is selected automatically. Before disconnect-
ing the battery for repair or replacement,
make sure to put the operation mode in OFF.
Be careful if you are not sure which opera-
tion mode the vehicle is in when the battery
is run down.
l
The operation mode cannot be changed from
OFF to ACC or ON if the keyless operation
key is not detected to be in the vehicle. Refer
to “Keyless operation system: operating
range for starting the engine ” on page 3-11.
l
When there is the keyless operation key in
the vehicle and the operation mode is not
changed, the battery in the keyless operation
key may have worn out. Refer to “Warning
activation” on page 3-14.
NOTE
l
If the operation mode cannot be changed to
OFF, perform the following procedure.
1
.
Move the selector lever to the “P”
(PARK) position, and then change
the operation mode to OFF. (For ve-
hicles with CVT)
NOTE
2
.
One of the other causes could be low
battery voltage. If this occurs, the
keyless entry system, keyless opera-
tion function and steering lock will
also not operate. Contact a
MITSUBISHI MOTORS Authorized
Service Point.
ACC power auto-cutout func-
tion
E00632801311
After approximately 30 minutes have elapsed
with the operation mode in ACC, the func-
tion automatically cuts out the power for the
audio system and other electric devices that
can be operated with that position.
When the engine switch operate again, the
power is supplied again.
NOTE
l
It is possible to modify functions as follows:
•
The time until the power cuts out can be
changed to approximately 60 minutes.
Engine switch*
6-16
OGKE18E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
