NOTE
•
After the engine restarts automatically
and the vehicle stops again within 10 sec-
onds
•
Engine coolant temperature is low
•
Ambient temperature is low
•
When using the heater, vehicle interior
temperature is not warm enough
•
Air conditioning is operating and passen-
ger compartment has not sufficiently
cooled
•
Demister switch is pressed
Refer to “Demisting of the windscreen
and door windows” on page 7-07.
•
When the air conditioner is operated in
automatic mode where the temperature
control is set to the max. hot or the max.
cool.
•
Electric power consumption is high, such
as when the rear window demister or oth-
er electrical components are operating or
the blower speed is set to a high setting.
•
Battery volume, voltage or battery per-
formance is low
•
Check engine warning lamp is illuminated
or the
indicator display is blinking.
•
The selector lever is other than in the “D”
(DRIVE) position (CVT)
•
ASC operation indicator and ASC OFF
indicator is turned on (CVT)
•
ABS warning lamp is turned on
•
CVT warning lamp will turn on/warning
display will display (CVT)
NOTE
l
In the following cases, the engine will not
stop automatically even if the indica-
tor display turned on.
•
Depress the accelerator pedal
•
Brake booster vacuum pressure is low
•
Operate the steering wheel
•
Brake pedal is not sufficiently depressed
(CVT)
•
Parking on steep hill (CVT)
•
Parking brake operates (CVT)
l
On vehicles equipped with M/T, do not rest
your foot on the clutch pedal while driving
because this will cause detection of clutch
pedal switch malfunction and blinking of
AS&G OFF display, and AS&G system will
not operate.
l
If the AS&G system operates while the air
conditioner is operating, both the engine and
the air conditioning compressor will stop.
Therefore, only the blower will operate, the
windows may start to fog up. If this occurs,
press the demister switch to restart the en-
gine.
Refer to “Demisting of the windscreen and
door windows” on page 7-07.
l
If the windows become fogged up each time
the engine is stopped, we recommend you to
deactivate the AS&G system by pressing the
“Auto Stop & Go (AS&G) OFF” switch.
Refer to “To deactivate” on page 6-28.
NOTE
l
If the air conditioner is operating, set the
temperature control higher to lengthen the
time that the engine is stopped automatical-
ly.
Automatically restarting the en-
gine (on vehicles equipped with
M/T)
Depress the clutch pedal while the gearshift
lever is in the “N” (Neutral) position. The
indicator display turns off and the en-
gine restarts automatically.
Automatically stopping the en-
gine (on vehicles equipped with
CVT)
Release the brake pedal. The indicator
display turns off and the engine restarts auto-
matically.
When the Brake auto hold operation indi-
cator is turned on (for vehicles equipped
with Brake auto hold)
When you depress the accelerator pedal, the
engine restarts automatically.
When the Adaptive Cruise Control System
(ACC) is turned on (for vehicles equipped
with the ACC)
Auto Stop & Go (AS&G) system
6-26
OGKE18E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
