NOTE
l
The drive mode can be switched while driv-
ing or stopped.
S-AWC drive mode display
E00639000083
Example: “AUTO” mode is selected.
The currently selected drive mode is dis-
played on the multi-information display.
In addition, when the drive mode is changed,
the selected mode appears on the interrupt
display screen of the information screen in
the multi-information display.
The drive mode display will appear on the in-
formation screen for a few seconds, and then
the original screen will return.
CAUTION
l
If the selected drive mode indicator is blink-
ing, the drive mode switches automatically
to protect the drive-system components.
The warning display is also displayed in the
information screen in the multi information
display.
Reduce speed, and if the indicator goes out
after driving a while, resume driving as be-
fore.
l
If the drive mode indicator is blinking, a
problem has occurred with the S-AWC sys-
tem and the safety device has activated. The
warning display is also displayed in the in-
formation screen in the multi-information
display.
Have your vehicle inspected immediately by
a MITSUBISHI MOTORS Authorized Serv-
ice Point.
CAUTION
l
Be sure to use tyres that are the same speci-
fied size, type, and brand, and have no dif-
ference in the amount of wear for all four
wheels. Otherwise, the S-AWC system may
not work properly.
S-AWC operation display
E00623101275
The S-AWC operation status can be dis-
played on the information screen in the multi-
information display.
To display the status, press the multi-infor-
mation display switch to change the informa-
tion screen.
Refer to “Information screen (when the oper-
ation mode is ON)” on page 5-05
Display example
The S-AWC operation status is displayed.
S-AWC (Super All Wheel Control)
6-39
OGKE18E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
