If the display keeps showing the message,
there is a possibility that the FCM has a mal-
function.
Contact a MITSUBISHI MOTORS Author-
ized Service Point.
NOTE
l
If the sensor or its surrounding area reaches
an extremely high temperature when parking
the vehicle under a blazing sun, the “FCM
SERVICE REQUIRED” message may ap-
pear.
After the temperature of the sensor or its sur-
rounding area has been in range, if the mes-
sage remains even after restarting the en-
gine, please contact a MITSUBISHI
MOTORS Authorized Service Point.
Handling of the sensor
E00652200239
The sensor (A) is located inside the wind-
screen and front bumper (Type 2 only) as
shown in the illustration.
The sensor is shared in the following sys-
tems:
l
Forward Collision Mitigation system
(FCM)
l
Lane Departure Warning (LDW)
l
Automatic High-Beam (AHB)
l
Adaptive Cruise Control System
(ACC)*
*: if so equipped
CAUTION
l
To maintain proper performance of the
FCM, LDW and AHB:
CAUTION
•
Always keep clean the windscreen and
front bumper (Type 2 only).
If the inside of the windscreen where the
sensor is installed becomes dirty or fog-
ged, contact a MITSUBISHI MOTORS
Authorized Service Point.
•
Do not apply an impact or load on the
sensor or its surrounding area.
•
Do not put anything including a sticker or
film to the outer side of the windscreen in
front of or surrounding area of the sensor.
Also, do not put anything including a
sticker or film to the inner side of the
windscreen under the sensor.
•
Do not attempt to detach or disassemble
the sensor and sensor mounting screw.
•
The sensor front cover should not be
modified or painted.
•
Do not cover the sensor mounted area
with a licence plate or anything such as a
grill guard, etc.
Forward Collision Mitigation System (FCM)
6-86
OGKE18E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
