EasyManuals Logo
Home>Mitsubishi>Automobile>ECLIPSE CROSS 2017

Mitsubishi ECLIPSE CROSS 2017 User Manual

Mitsubishi ECLIPSE CROSS 2017
538 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
NOTE
l
The time allowed for checking that the vehi-
cle is locked can be adjusted. For further in-
formation, please contact a MITSUBISHI
MOTORS Authorized Service Point. On ve-
hicles equipped with the Smartphone Link
Display Audio or the MITSUBISHI Multi-
Communication System (MMCS), screen
operations can be used to make the adjust-
ment. Refer to the separate owner’s manual
for details.
Unlocking the doors
When you are carrying the keyless operation
key, if you press the driver’s or front passen-
ger’s door lock/unlock switch (A), or the tail-
gate open switch (C) within the operating
range, all the doors and the tailgate are un-
locked.
If the front or the rear room lamp switch is in
the
or the position, at this time, the
room lamp will turn on for 15 seconds. The
turn-signal lamps will blink twice.
If the driver’s or front passenger’s door lock/
unlock switch is pressed and any of the doors
or tailgate is not opened within approximate-
ly 30 seconds, relocking will automatically
occur.
Also refer to Locking and unlocking:3-16,
3-18, 3-21.
NOTE
l
For vehicles equipped with the mirror retrac-
tor switch, the outside rear-view mirrors au-
tomatically extend when all the doors and
tailgate are unlocked using the keyless oper-
ation function.
Refer to “Starting and driving: Outside rear-
view mirrors” on page 6-10.
l
Except for vehicles equipped with a Dead
Lock System, the keyless operation function
can be set so that only the driver’s door un-
locks when the driver’s door lock/unlock
switch is pressed.
If the keyless operation function is set to
work as described above, all the doors and
the tailgate unlock when the driver’s door
lock/unlock switch is pressed two times in
succession.
(Refer to “Setting of door and tailgate un-
lock function” on page 3-06.)
l
The keyless operation function does not op-
erate under the following conditions:
The keyless operation key is inside the
vehicle.
The operation mode is not in OFF.
l
In order to make it possible to check that the
doors and tailgate are locked, you cannot un-
lock them by using the tailgate open switch
for 3 seconds after locking them.
NOTE
l
The time allowed for checking that the vehi-
cle is locked can be adjusted. For further in-
formation, please contact a MITSUBISHI
MOTORS Authorized Service Point.
On vehicles equipped with the Smartphone
Link Display Audio or the MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the
adjustment. Refer to the separate owner’s
manual for details.
l
The time between unlocking and automatic
locking can be adjusted. Please consult a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
On vehicles equipped with the Smartphone
Link Display Audio or the MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the
adjustment. Refer to the separate owner’s
manual for details.
Operation confirmation when locking and
unlocking
Operation can be confirmed as shown below.
However, the room lamp will only illuminate
if the front or the rear room lamp switch is in
the “
” or the “” position,
When locking: The turn-signal lamps blink
once.
When unlocking: The room lamp illuminates
for approximately 15 seconds, the turn-signal
lamps blink twice.
Keyless operation system*
3-12
OGKE18E1
Locking and unlocking
3

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi ECLIPSE CROSS 2017 and is the answer not in the manual?

Mitsubishi ECLIPSE CROSS 2017 Specifications

General IconGeneral
BrandMitsubishi
ModelECLIPSE CROSS 2017
CategoryAutomobile
LanguageEnglish

Related product manuals