12. After injecting the sealant, securely fit
the valve remover (E) into the end of the
filler hose (J) to prevent sealant from
leaking from the empty bottle.
13. Pull out the compressor hose (K) from
the side of the tyre compressor, and then
securely attach the hose to the tyre valve
(D).
14. Place the compressor (L) with its air
pressure gauge (M) on top.
Pull out the compressor’s power cord
(N), insert the plug on the cord into the
accessory socket (O), and then put the
operation mode in ACC. (Refer to “Ac-
cessory socket” on page 7-82.)
Turn ON the compressor switch (P) and
inflate the tyre to the specified pressure.
(Refer to “Tyre inflation pressures” on
page 10-11.)
CAUTION
l
The supplied compressor is designed only
for inflation of your vehicle tyres.
l
The compressor is designed to run on a vehi-
cle’s 12 V power supply. Do not connect it
to any other power source.
Tyre repair kit*
8-10
OGKE18E1
For emergencies
8
To Next Page
Loading...
Need help?
General
