207
Motor brake and stop operation
4
PARAMETERS
(3) Set frequency when stop-on-contact control (Pr. 270 = 1, 3) is selected
⋅ The following table lists the frequencies set when the input terminals (RH, RM, RL, RT, JOG) are selected together.
Bold frame indicates stop-on-contact control is valid.
⋅ Stop-on-contact control is disabled when remote setting function is selected (Pr. 59 = 1 to 3).
CAUTION
⋅ Changing the terminal function using any of Pr. 178 to Pr. 189 may affect the other functions. Please make setting after confirming
the function of each terminal.
♦ Parameters referred to ♦
Pr. 4 to Pr. 6, Pr. 24 to Pr. 27 (multi-speed setting) Refer to page 160
Pr. 15 Jog frequency Refer to page 162
Pr. 22 Stall prevention operation level, Pr. 48 Second stall prevention operation current Refer to page 144
Pr. 22 Torque limit level Refer to page 94
Pr. 59 Remote function selection Refer to page 164
Pr. 72 PWM frequency selection Refer to page 272
Pr. 79 Operation mode selection Refer to page 301
Pr. 95 Online auto tuning selection Refer to page 191
Pr. 128 PID action selection Refer to page 348
Pr. 178 to Pr. 189 (input terminal function selection) Refer to page 222
Pr. 270 = 2, 3 (load torque high speed frequency control) Refer to page 361
Input Signal (
= on)
Set Frequency
RH RM RL RT
JOG
Pr. 4
Multi-speed setting (high speed)
Pr. 5
Multi-speed setting (middle speed)
Pr. 6 Multi-speed setting (low speed)
By 0 to 5V(0 to 10V), 4 to 20mA
input
Pr. 15 Jog frequency
Pr. 26 Multi-speed setting (speed 6)
Pr. 25 Multi-speed setting (speed 5)
Pr. 4 Multi-speed setting (high speed)
Pr. 15 Jog frequency
Pr. 24 Multi-speed setting (speed 4)
Pr. 5
Multi-speed setting (middle speed)
Pr. 15 Jog frequency
Pr. 6 Multi-speed setting (low speed)
Pr. 15 Jog frequency
Pr. 15 Jog frequency
Pr. 15 Jog frequency
Pr. 15 Jog frequency
Pr. 15 Jog frequency
Pr. 6 Multi-speed setting (low speed)
Pr. 15 Jog frequency
Pr. 15 Jog frequency
Pr. 6 Multi-speed setting (low speed)
Pr. 15 Jog frequency
Pr. 26 Multi-speed setting (speed 6)
Pr. 27 Multi-speed setting (speed 7)
Pr. 15 Jog frequency
Pr. 15 Jog frequency
Pr. 15 Jog frequency
Pr. 15 Jog frequency
Pr. 6 Multi-speed setting (low speed)
Pr. 15 Jog frequency
By 0 to 5V(0 to 10V), 4 to 20mA
input
Input Signal (
= on)
Set Frequency
RH RM RL RT
JOG
To Next Page
Loading...
