438
Installation of the heatsink portion
outside the enclosure for use
(2) Shift and removal of a rear side installation frame
• FR-A740-04320 to 06830
One installation frame is attached to each of the upper and lower
parts of the inverter. Change the position of the rear side
installation frame on the upper and lower sides of the inverter to
the front side as shown on the right. When changing the
installation frames, make sure that the installation orientation is
correct.
• FR-A740-07700 or more
Two installation frames each are attached to the upper and lower
parts of the inverter. Remove the rear side installation frame on
the upper and lower sides of the inverter as shown on the right.
Upper
installation
frame
Lower
installation
frame
Shift
Shift
Removal
Upper installation
frame (rear side)
Removal
Lower installation
frame (rear side)
To Next Page
Loading...
