§ 5.
(-
hS+V.”
SETTING 0~ CONTROL VARIABLES (PARAMETERS)
The inverter has various control functions.
To assure the best performance
from your inverter and motor, these functions should be used with care and
thought for application to the driven machine.
These functions can be set, and setting can be checked or changed by
operating the PU.
Control functions and setting method
1 ” READ ” and ” WRITE ” of function . . . . See P.94
Basic control
[ ftztions 1 functions
H~+KEJ.~ 1
Secondary functions
(operating conditions,
&C.)
3 rd Auxiliary functions
functions (calibration. etc.)
( /ziq ) * piEq
1 Change (write) 1
Setting should be
changed after check.
[SET VALUEI l I-1
2
" ALL CLEAR " . . . . .
By performing the following operation, user’s settings
are reset to the initial settings (i.e., setting made at
shipment of inverter) .
After pizq is pressed,
llTTmKl
appears and flickers.
1
I I
I 3l
Prohibition of parameter WRITE
-83-
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
