5.2 Examples of operation
(1) Setting of
1 st function (acceleration/deceleration time)
Key 1 m -
Display
Setting
of acceleration
Read
present value
Change to IOsec.
Write
time
.
Initial setting
Note: When another 1 st function must be set after the 1 st function has
been set, the new desired function can be called by just pressing the
corresponding function
key
(that is, lsETJ key is not required to be
pressed) .
(2) Setting of 2 nd’ function (frequency reference for JOG operation)
\
KCY
Display
Selection of 2 nd function
@Ia.dj -
Setting of frequency
for JOG operation
Read present value Change to 1OHz Write
pjqy-q 1-j [I Irlo.lz_loi
(5Hz)
(10Hd
Initial setting
.
Note: 1 .
A dot is placed after p r when the 2 nd function is selected,
like p r. .
2. When another 2 nd function has to be set immediately after a
2 nd function has already been set, the new desired function can
be called by pressing
I
2 nd key, and specifying the function No.
( [=I key is not required to be pressed) .
-85-
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
